Consteel Electric Arc Furnace Process
…rule to be followed is that the maximum scrap piece is not to exceed the distance between the tip of the Consteel process conveyor and the electrodes, in order to…
Read MoreMeasurement Standards
…such an instrument very useful if it, in fact, is only accurate 5 % of the time. When such a statement is made, it is meant that the instrument’s inaccuracy…
Read MoreBlast Furnace Stock House
…to configure the charging matrix considering plant based set of rules programmed in the application software. The complexity of stock house operator matrix is generally validated by different validation rules…
Read MorePreparation and Charging of Blast Furnace Burden
…between macro-structural (bulk) behaviour to the underlying micro-structural (discrete) dynamics is to be established. Collision-dominated flows – In collision-dominated flows, the flow is dispersed, scattered and energetic, with particles interacting…
Read MoreWire and Rod Drawing Process for Steel
…the die. Thus, the difference between drawing and extrusion is that in extrusion the material is pushed through a die, whereas in drawing it is pulled through it. Although the…
Read MoreFormation of Scaffold in Blast Furnace Shaft
…movement of the burden. The hanging can rupture, and then the material fall down because of the gap which has been created below the hanging. After, the rupture, when the…
Read MoreGrease and Grease Lubrication
…the shearing of grease in the friction node, the size of the particles can change considerably. Microstructure of the lubricating greases Microstructure of the lubricating greases with soap thickeners can…
Read MoreLubrication and Lubricating Oils
…physical and chemical properties that actually exists, or of the nature of the lubricating base stocks which can be produced from a particular crude oil. The chemical structure of lubricating…
Read MoreStraightening Machines in Flat Rolling Mills
…amount of deflection when running the narrower material. The forces and stresses are now concentrated at the centre of the rollers. This area is furthest from the end journals and…
Read MoreSteel Pipes and Tubes
…8 %) than austenitic stainless steels. They are identified by a dual phase microstructure. They have a well balanced two phase structure consisting of both ferritic structure and austenitic structure….
Read More