Types of Burners in Reheating Furnaces Jan08

Types of Burners in Reheating Furnaces...

Types of Burners in Reheating Furnaces Presently steel industry is facing major challenges of the continuous reduction of the  environmental emissions while improving the economic viability of the processes. Reheating furnaces due to their high-energy consumption is one area where attention of steel industry is needed. They are important equipment which contribute to the productivity and energy efficiency of the steel plant. Modern reheating furnaces are walking beam furnaces where the beams lift the charge steel material (billets, blooms or slabs) inside the furnace and move it to the next position. The heating is done in these furnaces by direct firing of the fuel both from above and below of the steel charge material, using roof burners (to heat the roof which then radiates the heat to the steel charge material) and/or long flame burners (side walls or/and front wall). Common fuels used in the reheating furnaces are mixed gas of low calorific value (blast furnace gas mixed with the coke oven gas and the converter gas), coke oven gas, heavy oil, low sulphur heavy stock (LSHS), or natural gas. The important  parameters for a reheating furnace includes  the combustion system consisting of the fuel used, supply and the technological condition of the combustion air, the burners and their location for proper heat distribution, preheating of combustion air and fuel gas, waste heat recovery system, air fuel ratio, control of furnace draft, the furnace exhaust system, and furnace parameters measurement and control system.  The furnace combustion system besides supporting the required productivity level of the furnace, ensures efficient utilization of heat input, lower heat losses, efficient recovery of waste heat, minimal damage to the furnace refractories, and lower generation of green house gases specially NOx. The furnace combustion system also ensures a furnace atmosphere...