Energy Management in Small and Medium sized Re-rolling mills...

Energy Management in Small and Medium sized Re-rolling mills Energy consumption in small and medium sized re-rolling mills takes place in two forms namely (i) electrical energy, and (ii) fuel or heat energy. Electrical energy is used directly in main rolling process for shaping of hot billets into rolled product (rolling mill, and shears etc.), in reheating furnace (coal pulverizer, blower, and pusher etc.) and also in auxiliary (roll turning machines, pumps, man coolers, overhead crane etc.), and shop lighting. Fuel energy is used in the reheating furnace for raising the temperature of the feed material to desired temperatures (generally 1150 deg C–1250 deg C). The division of the energy in these two forms normally varies from mill to mill based on the practices employed as well facilities installed in the re-rolling mills in SME (small and medium enterprise) sector. However, the share of electrical energy in small and medium sized mill generally varies in the range 20 % to 30 %. Consumption of fuel energy takes the major share of the energy consumption and usually constitutes 70 % to 80 %. From a theoretical perspective, the energy in hot rolling is primarily determined by the requirements of reheating of feed material. The theoretical energy for deformation is only 0.02 GJ/ton (around 5000 kcal/ton), compared to 0.83 GJ/ton (around 200,000 kcal /ton) for heating billets when charged cold in the reheating furnace. Though it is not technically feasible to achieve theoretical energy consumption figures, but the energy efficiency of the rolling mill is depends upon how close it is to the theoretical consumption. Management of electrical energy consumption Out of the total electrical energy consumed by a re-rolling mill, the share of the process of rolling is in the range of around 60 %...